Carnauba Wax Paste | HP-CX7
Carnauba wax based release agent for high gloss finished surfaces. Free of silicone, PTFE, morpholine or turpentine.
Features and properties
- Wax release agent for brilliant high glossy finish in moulds with smooth, non porous surfaces (metal, plastics, varnished wood or MDF)
- Suitable for most composites mould applications with solvent free epoxy and polyester resins
- Primer for film release agent HP-PVA
- High-gloss release agent for working with In-Mould Coating HP-IMC (HP-Textiles)
Processing guidelines
1. Clean and degrease the mould surface.
2. Apply HP-CX7 with a soft cloth in an area of approx. 70 x 70 cm in circular motion.
3. Polish directly (within 10 minutes) with a clean towel and buff carefully to a brilliant, hard finish.
New moulds:
Apply HP-CX7 minimum 4-6 coats. Allow to set 1-2h between each working step.
After the last coat, you should wait >6h (better over night) before laminating.
After each of first-three demoulds, it is necessary to apply a new coat.
Seasoned moulds:
If necessary, apply a new coat HP-CX7 and wait for setting at least for 1h.
Recommended working temperature is between +20 and +30°C.
Technical Data Carnauba Wax Paste HP-CX7
- Form : liquid
- Appearance : beige-yellow / grey-brown
- Smell : characteristic
- Density : 0.88 g/ml (at 20°C)
- Flashpoint : > 65 °C
- Ignition Temp. : > 300 °C
- Explosion limits : 0.6 – 8.5 Vol.-% (solvent)
- Application temperature : < 80 °C
- Consumption : 15 - 20 g/m² (one tin (425g) suffices for approx. 25 m²)
Working notes and decision guidance
Below you will find processing information for epoxy resins, safety notes and also a decision guide for helping choosing the correct epoxy system.Decision guidance epoxy resins (PDF)
Decision support Release Agent (PDF)
If you need further working notes and decision guidance, you will find anything here in the download portal.
.jpg "Preview: 160 g/m² Carbon Fabric Twill | HP-T160C")
