Silicon Moulding / Cast Resin

• Transparent, low shrink-casting with tacky-free surfaces
• Very good flow behaviour (low-viscosity)
• Cold-hardening, demouldable at room-temperature
• High fillable casting resin
• Cause pressure-resistant and impact-resistant (tough) moulds / components with high strength and very less shrinkage

The Epoxy-System HP-E45KL is an unfilled, medium-viscous, chemical resistant combination of resin and hardener with working time (pot life) about 45 minutes. It is versatile for laminating and for bonding / gluing applications.

Bonding, Laminating, Mould Making

• High-quality mould covering resin
• Non-drip, without run-off on vertical surfaces -high thixotropic, blue-grey coloured
• Vacuum degassed
• User friendly mixing ratios (100:10)
• For abrasion-and breaking resistance surfaces with good thermal conductivity.
• Innovative formulation, free of DETA1 with high styrene resistance.

• Foundry patterns, die plates, reproduction patterns
• Building small moulds and castings with slightly yellow colour
• Encapsulation of decorative elements
• Gevelling compound

• 2K epoxy resin casting system
• Very good casting properties
• Low viscous (thin)
• Pot life 45 min
• Slight intrinsic colour

• 2K epoxy resin electro casting compound
• Excellent casting properties
• Low viscous (thin)
• Pot life 45 min
• Good light stability

• Low heat generation
• Easy to use and odourless
• Possible addition of water up to 5%
• Mixable with dry colour pigments
• Addition of cotton flakes to increase the viscosity
• Working time (pot life): 10-20 minutes (100g at 20°C)

• Excellent thickening effect for SI30GB
• Solvent-free
• Dilution of condensation and additioncuring RTV-2 silicone systems
• Optimization of the gradient properties

• Excellent dilution effect
• Solvent-free
• Dilution of condensation and additioncuring RTV-2 silicone systems
• Optimization of the gradient properties
• Dosage till 10 %
• Quantity: 500 g