Casting System (transparent) - Epoxy Resin | HP-E50GB
Casting system, pouring, transparent | Epoxy Resin HP-E50GB
The Epoxy-System HP-E50GB is an unfilled, low-viscosity combination of resin and hardener with working time (pot life) about 40 minutes. Usable for epoxy casting of medium thickness (up to approx. 15mm) depending on surface, temperature geometries and casting quantity (volume).
Technical data:
| Colouring: | Transparent |
| Mixed Viscosity: | Low viscous |
| Working Time (pot life): | 40 minutes (100g at 20°C) |
| Working temperature (optimum): | 15 - 25 °C |
| Working temperature (minimum): | 10 °C |
Areas of application:
Levelling compound / injection resin for structural repairs, encapsulation of decorative elements, building of medium moulds and castings, industrial modelling, hobby modelling, boatbuilding, ...
Properties and application notes:
- Transparent, low shrink-casting with tacky-free surfaces
- Very good flow behaviour (low-viscosity)
- Cold-hardening, demouldable at room-temperature
- High fillable casting resin
- Cause pressure-resistant and impact-resistant (tough) moulds / components with high strength and very less shrinkage
► Laminate calculator
Here you can calculate specific values for the vacuum infusion.
Working notes and decision guidance for Epoxy Resins
Below you will find processing information for epoxy resins, safety notes and also a decision guide for helping choosing the correct epoxy system.Practical tips for epoxy resins (PDF)
Epoxy resin for boat building (PDF)
Decision guidance epoxy resins (PDF)
Hazard Statements
Resin:
Warning
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H319 Causes serious eye irritation.
H411 Toxic to aquatic life with long lasting effects.
Hardener:
Danger
H302+H312 Harmful if swallowed or in contact with skin.
H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H412 Harmful to aquatic life with long lasting effects.
.jpg "Preview: 420 g/m² Carbon Fabric Twill | HP-T421/125C")
