Stud to close 12 mm | HP-VZ1170

The injection- / infusion-resins of the series HP-E3000RI show very low viscosities,
what supports excellent wet-out and flow properties. The hardener HP-E30RI allows a pot-life of 200 minutes. The series is usable for hand-laminating too.

Vacuum Infusion, Pressure Injection

• Water based release agent for applications with In-Mould Coatings (HP-IMC) from HP-Textiles.
• Also suitable for solvent free epoxy resins, unsaturated polyester resin and vinyl ester resins.
• Fast drying time (per layer <5 minutes at 20°C)
• Semipermanent, external release agent with good demoulding features
• Minimises remains on the moulds’ surface – and at the same time no transmission to the component

The injection- / infusion-resins of the series HP-E3000RI show very low viscosities,
what supports excellent wet-out and flow properties. The hardener HP-E30RI allows a pot-life of 200 minutes. The series is usable for hand-laminating too.

Vacuum Infusion, Pressure Injection

• Water based release agent for applications with In-Mould Coatings (HP-IMC) from HP-Textiles.
• Also suitable for solvent free epoxy resins, unsaturated polyester resin and vinyl ester resins.
• Fast drying time (per layer <5 minutes at 20°C)
• Semipermanent, external release agent with good demoulding features
• Minimises remains on the moulds’ surface – and at the same time no transmission to the component

• Strain Gauge Precision Technology
• Capacity: up to 10kg
• Readability: 1g
• Display Modes: g / kg / oz / lb / tl
• Key with Full Function: ON/OFF/TARA/ZERO
• Auto/Manual Shut-Off
• Powered by Battery (included) or Power Adapter