Casting System - Epoxy Resin | HP-E45GA
TOP
Casting system, transparent | Epoxy Resin System HP-E45GA
The Epoxy-System E45GA is an unfilled, medium-viscosity combination of resin and hardener with working time (pot life) about 45 minutes. Usable for epoxy casting of medium thickness (up to approx. 20 mm)
Technical data:
| Mixing ratios (by weight): | 100 parts resin : 100 parts hardener |
| Working time (pot life): | 6-8 minutes (100 g at 20°C) |
| Working temperature: | 20-23 °C |
Areas of application:
Foundry patterns, die plates, reproduction patterns, Building small moulds and castings with slightly yellow colour, Encapsulation of decorative elements, Gevelling compound, ...
Properties and application notes:
- Semi-transparent, low shrink-casting with tacky-free surfaces
- Good flow behaviour (medium-viscosity)
- Cold-hardening, demouldable at room-temperature
- High fillable casting resin
- Cause pressure-resistant and impact-resistant (tough) moulds / components with high strength
► Laminate calculator
Here you can calculate specific values for the vacuum infusion.
Working notes and decision guidance for Epoxy Resins
Below you will find processing information for epoxy resins, safety notes and also a decision guide for helping choosing the correct epoxy system.Practical tips for epoxy resins (PDF)
Decision guidance epoxy resins (PDF)
Hazard Statements
Resin:
Warning
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H319 Causes serious eye irritation.
H411 Toxic to aquatic life with long lasting effects.
Hardener:
Danger
H302+H332 Harmful if swallowed or if inhaled.
H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H412 Harmful to aquatic life with long lasting effects.
.jpg "Preview: 160 g/m² Carbon Fabric Twill | HP-T160C")
