Priming Wax | HP-G
Priming Wax | HP-G
Highly effective wax primer for barely wettable and porous surfaces.
Features and applications
- Foundation for Film Release Agent HP-PVA
- Good release properties
- Drying time approx. 5-15 minutes
Processing guidelines
Stir before and while using.
Apply HP-G stripe-free and do not polish afterwards. The surface stays dull after drying. Remaining HP-G can be removed with the HP-XB Thinner after removing the component from the mould.
The consumption is approx. 30ml/m² but it is determined by the quality of the underground.
We recommend for a safe separation the combination with HP-PVA.
In this case the HP-G is the foundation on porous and absorbing surfaces for the following layer, the Film Release Agent.
The processing temperature is at + 15°C up to + 30°C, the operating temperature is at maximum 20°
Technical Data Priming Wax | HP-G
- Form : viscous
- Colour : beige
- Smell : characteristic
- Density : 0,80 g/ml (at 20°C, DIN 51757)
- Flash point : < 21 °C (EN ISO 1523)
- Viscosity : > 90 sec. (flow cup 4mm, DIN EN ISO 2431)
Working notes and decision guidance
Below you will find processing information for epoxy resins, safety notes and also a decision guide for helping choosing the correct epoxy system.Decision guidance epoxy resins (PDF)
Decision support Release Agent (PDF)
If you need further working notes and decision guidance, you will find anything here in the download portal.
Hazard Statements
Priming Wax
H225 Highly flammable liquid and vapour.H336 May cause drowsiness or dizziness.
H412 Harmful to aquatic life with long lasting effects.
