Covering System - Topcoat - Epoxy Resin | HP-E40D
Covering System - Topcoat - Epoxy Resin | HP-E40D
This epoxy-system is an transparent, unfilled combination of resin and hardener with medium working time and low viscosity.
Features & Benefits
- High resistance to UV radiation, very slight yellowing
- Good wet-out of reinforcement fibres
- Cause bright, non-gluey (tack-free) surfaces and casts; suitable for carbon-look laminates (observe Tg MAX)
- Cold-hardening, applicable from 10°C
- Additional usable for transparent coating (floor coating as well) or casting up to 10mm layer-thickness
Product Properties Epoxy System E40D
- Colouring: colourless / clear
- Mixing Ratio (by weight): 100 parts resin : 50 parts hardener
- Mixed Viscosity: low viscous
- Working Time (pot life): 40 minutes (100g at 20°C)
- Working temperature (optimum): 15 - 25 °C
- Working temperature (minimum): 10 °C
Working notes and decision guidance for Epoxy Resins
Below you will find processing information for epoxy resins, safety notes and also a decision guide for helping choosing the correct epoxy system.Practical tips for epoxy resins (PDF)
Epoxy resin for boat building (PDF)
Practical Tips Carbon Coating (PDF)
Decision guidance epoxy resins (PDF)
Hazard Statements
Resin:
Warning
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H319 Causes serious eye irritation.
H411 Toxic to aquatic life with long lasting effects.
Hardener:
Danger
H302+H312 Harmful if swallowed or in contact with skin.
H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H412 Harmful to aquatic life with long lasting effects.
