Epoxy Priming Resin - Grounding - Resin & Hardener | E80FS
Epoxy Resin System, Primer, Adhesion Promoter and Corrosion Protection
The Epoxy System E80FS is an unfilled, low-viscosity combination of resin and hardener with high adhesionto several surfaces.
Features & Benefits
- Very good wetting
- Causes tacky-free surface
- Osmosis protection, filler for wooden porosities
- Water barrier layer
- Primer / Adhesion Promoter for several surfaces:
- thermosetting plastics, GRP- or CRP-parts, (melamine) resin plates
- wood, glulam (timber), plywood (sev. kinds)
- concrete, brick wall, cement plaster or other surfaces / substrates - Corrosion Prevention for metal / aluminium (bare)
- Further build-up, with
- adhesives or laminating-resins (epoxy, polyester1)
- paints (acrylic-, alkyd-, epoxy- or polyurethane-based)
Product Properties Epoxy System E80FS
Colouring: yellowish / brownishMixing Ratio (by weight): 100 parts resin : 60 parts hardener
Mixing Ratio (by volume): 100 parts resin : 68 parts hardener
Mixed Viscosity: low viscous
Working Time (pot life): 35 minutes (100g at 20°C)
Gel-time approx.: 2-3 h (0.2mm layer thickness at 23°C)
Earliest sandable after / tacky-free as from: 6 h (0.2mm layer thickness at 23°C)
Working temperature (optimum): 20 - 25 °C
Working temperature (minimum): 15 °C
Working notes and decision guidance for Epoxy Resins
Below you will find processing information for epoxy resins, safety notes and also a decision guide for helping choosing the correct epoxy system.Practical tips for epoxy resins (PDF)
Epoxy resin for boat building (PDF)
Decision guidance epoxy resins (PDF)
Hazard Statements
Resin:
Warning
H315 Causes skin irritation.
H317 May cause an allergic skin reaction.
H319 Causes serious eye irritation.
H411 Toxic to aquatic life with long lasting effects.
Hardener:
Danger
H314 Causes severe skin burns and eye damage.
H317 May cause an allergic skin reaction.
H411 Toxic to aquatic life with long lasting effects.
