High-Gloss Release Agent | HP-HGR5

Water based High-Gloss Release Agent | HP-HGR5

HP-HGR5 is a release agent for In-Mould Coating HP-IMC and other thermosetting resins by HP-Textiles. Enables demouldings / castings with high gloss qualities. Very low consumption, short drying time, high effectivity.

Features and Benefits

• Water based release agent for applications with In-Mould Coatings (HP-IMC) from HP-Textiles.
  Also suitable for solvent free epoxy resins, unsaturated polyester resin and vinyl ester resins.
• Fast drying time (per layer <5 minutes at 20°C)
• Semipermanent, external release agent with good demoulding features
• Colourless, solvent-free
• Application with spray gun (ready for spraying), lint-free cloth or soft brush possible
• Can be polished after short dry time
• Multiple demoulding processes are possible
• Minimises remains on the moulds’ surface – and at the same time no transmission to the component

Processing guidelines

Stir up well before use.
Clean the moulds’ surface well before applying the resin.

New moulds:
Apply HP-HGR5 in at least 2-3 layers.
Consider a waiting time of a few minutes* between each working step.
If higher gloss is required, it is possible to polish the surface after a few minutes waiting time.
If the last coat is finished, it´s recommended to wait approx. 30 min* before laminating.
Especially after each of the first demoulding processes, it is recommended to apply a new layer of the release agent.

Used moulds:
Clean the moulds’ surface and remove every other release agent carefully.
After that, apply HP-HGR5 as per description.
* All information shall apply at 20°C! Higher temperatures will shorten the drying time. At mould temperatures of >60°C you have to pay attention to the correct usage of the surface!
Remains of the release agent HP-HGR5 can be removed with water (with addition of detergents).